Checked sparkplugs, no issues were found, did compression test, 150 psi average on all cylinders, code for cam position system performance, pulled vvt solonoid and found large amounts of debris on solonoid.
VARIABLE VALVE TIMING OIL CONTROL VALVE SOLENOID – Remove & Replace – Both, Intake & Exhaust – [NOTE: Labor estimates listed are for R&R only and DOES NOT include diagnosis time.]
SYNTH LUBE OIL & FILTER
TINA B. gave our service a 5 star review on 6/26/2026
Purge valve is trying to compensate for leak and commanding to much Purge causing rough idle and misfire.
Checked wiring at control arm, and connection at wheel bearing no issue was found, watched data while driving, no signal drop out occurred. Lights did come on while on second test drive, pulled codes and code for left front speed sensor circuit fault was present, recommend replacing wheel bearing.
Evap large leak code is present, did smoke test, fuel cap was leaking, removed cap and noticed it was the incorrect cap for the car, replaced cap no leak returned, tested purge vent solonoid, no issue was found.
DAVID H. gave our service a 5 star review on 4/14/2026
Had code p2135 T.P.S correlation code.Cut apart repaired harness and inspect repair. Has 20 gauge wire spliced into 14-16 gauge wire connectors.Cut out 20 + feet of wire .Re connected wires with proper connectors heat shrink and ran harness zip tied to O.E harness.Test drove to Glide and back no problems at this time.
RUSS R. gave our service a 5 star review on 12/16/2025